Jump to content
RESET Forums (homeservershow.com)

Installing 2 Ceton tuners on Server 2008 R2

Greg Welch

Recommended Posts

I have decided to follow the directions i found here:

and would like any ideas to perfect this setup



they work great for 1 tuner


so i am try the following :)


I have installed 2 ceton tuners on my server 2008 R2 ,


1.both show up in server manager, without error ,

2.have set both to support bridging in server manager

3. under network sonnections i have renamed them ceton 1 and ceton 2

4. under Network i see 2 tuners

a. so i went to the tuners device webpages

ceton1: ip


b. unchecked defualt IP settings

set static ip's to just outside my dhcp range




dhcp client isnt checked

5. doesnt want to complete the static sets, circles next to explorer tabs keep spinning


6. went to step 10 of guide above and chose Ceton 1 and Ceton 2 and a physical Intel Pro 82576 gigabit nic and bridged the 3 of them

I will be using the tuners on VM and a stand alone media center on the network


7. network connections now shows Network bridge

( that consists of 2 cetons and 1 intel physical nic)


8. first pc (a VM) , has remotefx installed

a. i went to network and say 2 ceton tuners

b. installed ceton software 1.5.4304.06-20111017 x64bit

c.prayed (kinda)

d.diagnostic tool, top drop down shows both ceton tuners

e. firmware

hardware 4884

9. ran guide above , step 1-

a. both tuners show up after clicking tuner setup in media center


have fun, welchwerks

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Create New...