Jump to content
RESET Forums (homeservershow.com)

Guessing my MB died


bigo93
 Share

Recommended Posts

Well my microserver started having a red flashing health LED
4Hz, which claims to be a power fault.
Reseated all cables, removed drives and ram, still red LED.
Will not power up at all.

 

Integrated Management Log shows
 

257   System Revision [NOT SET] [NOT SET] 1 Firmware flashed (iLO 4 2.78)
  256   Power 01/01/1970 00:01 01/01/1970 00:01 18 System Power Fault Detected (XR: 20 00 MID: FF F5 FE 01 FF FF FF 06 06 00 00 02 01 85 40 01 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00)
  255   POST Message 05/05/2021 11:17 05/05/2021 11:17 1 POST Error: 1785-Slot X Drive Array Not Configured
  254   Maintenance 05/05/2021 11:09 05/05/2021 11:09 1 Maintenance note: Intelligent Provisioning was loaded.
  253   Maintenance 05/05/2021 10:49 05/05/2021 10:49 1 Maintenance note: Intelligent Provisioning was loaded.
  252   System Revision 05/05/2021 10:22 05/05/2021 10:22 1 Firmware flashed (iLO 4 2.50)
  251   Maintenance 05/05/2021 10:02 05/05/2021 10:02 1 Maintenance note: Opt-in
  250   Maintenance 05/05/2021 10:02 05/05/2021 10:02 1 Maintenance note: Intelligent Provisioning was loaded.
  249   POST Message 05/05/2021 10:48 05/05/2021 10:00 3 POST Error: 1785-Slot X Drive Array Not Configured

 

Then for some reason the rest of the page is just spamming of POST Error: 1785-Slot X Drive Array Not Configured

 

I updated ilo to 2.78 after issue to see if that would reset anything, but no still flashing red LED 😢

 

So guess dead motherboard then?

 

Edited by bigo93
Link to comment
Share on other sites

It may also be a BIOS issue? Have you tried resetting the internal switches (can’t hurt if it’s given up the ghost)? I remember having an issue related to Intelligent Provisioning and all the onboard RAID and BIOS software (sorry I can’t remember what it’s all called, I’m not that technical lol). My issue was fixed by resetting both software and hardware and it stopped the red lights.

Link to comment
Share on other sites

  • 2 weeks later...

I have tried a PC PSU, still a red light.

Tried swapping to backup BIOS in iLO, not sure if it worked in swapping it, but still red light

I set switch 1,5,6 I think to reset the CMOS, still red light.
Or do I have to set all 12 switches to on?

Edited by bigo93
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

×
×
  • Create New...