My HP Proliant Microserver Gen 8 won't install HP Tools when I have running HP Smart Update Manager.
even when I have trying to install via Intelligent Provising, Windows Server 2019.
Se image below 🙂 That's I missing.. ;-(
New to this forum.
I have a gen8 microserver running at home, where I have installed an SSD in the ODD sata slot. On the SSD I have installed Ubuntu Server 18.04.
I have then created a logical volume witht the raid controller and can then boot to the SSD. So far so good.
My problem emerges when I reboot the system. The logical volume disapears and it gives the error: "boot logical drive is configured but is missing or offline".
I then have to go into the utility and reconfigure the logical volume. Kind of annoying, when trying to run a headless setup.
Good day all
i bought a gen 10 x3216 MicroServer and I have been trying to install windows server 2016 on it with a usb and I get it to boot into the usb with the iso on it but I can not get past the one install step where u supposed to select the drive.
instead it says to download storage drivers and browse to select driver. I have downloaded every single storage driver from the hpe site or is sure does feel like it.
if I try to select the driver I have to do so manually by unticking show only compatible drivers because if I leave it ticked there is nothing compatible. Iam stumped on what the correct driver is.
ok so what Iam trying to do isssssss I want to install the os onto the usb that I have attached inside the box the one that is directly coming off the board. Is that a different driver ?
In bios/boot up options I can see all usb connected.
can anyone please help me with this
By Mark Belanger
I'm new to the HPMSG8 world and so far I'm loving it. I have a stock Xeon with 16G of aftermarket memory with iLO patched to 2.70. Next up is adding a RAID card, so I can put my boot SSD on the onboard RAID. I picked up a LSI SAS9211-8i on Amazon, but am struggling to flash it to IT mode on the MicroServer. Is this even possible? Unfortunately, the only other system I have with PCI slots is 32-bit.
Any pointers would be greatly appreciated.
I need to update the firmware on a HP Proliant Microserver Remote Access Card installed in my N40L.
Can someone please explain what I need to do to create a boot device that will update the firmware on the Remote Access Card?