Jump to content
RESET Forums (homeservershow.com)
Sign in to follow this  
Joe75

Gen8 Network Adapter is dead?

Recommended Posts

Joe75

Hi All,
one week ago I received a Gen8 on which I was planning to install windows server 2019.
The setup was fine and I went on with other configurations. Last night, while i was configuring IIS, the server dropped me out.

 

After a quick check i found the ethernet port 2 switching on and off every 5 seconds. (left led signal)
While the other ethernet port 1 was dead (no led on, ever).

If i switch off the server the ethernet led stays on, so I suppose the driver is conficting with firmware…

 

windows log reports thousend of times:
    • Network Configured for 100Mb full-duplex link
    • The network link is down

 

windows driver is 16.4.0.1  (16/10/2013)
I upgraded the firmware of NX1 Broadcom to 5.0.0.24

 

    • What are the correct versions driver/firmware to be installed?
    HPE site is not very helpfull
 
    • The fact that Ethernet 2 led is always off suggest a hardware issue?

 

 

Many thanks

Joe

 

Obviously I changed cables and switch.

 

 

 

 

 

Edited by Joe75
typo

Share this post


Link to post
Share on other sites
netware5

Do you have UPS connected to one of USB ports? If the answer is YES, disconnect it, poweroff the server, remove power plug, wait 30 seconds, power again and try without UPS connected.

 

Share this post


Link to post
Share on other sites
Joe75

No UPS attached.

thanks anyway,

Edited by Joe75

Share this post


Link to post
Share on other sites
Joe75


If I look the system information inside iLo I see Firmware and status undefined.
normally this information is reported?
 
Adapter 2 - NIC
Location Embedded
Firmware N/A
Status

Unknown

 
Unknown Ports
MAC Address
d0:bf:9c:45:8f:f8
d0:bf:9c:45:8f:f9

Share this post


Link to post
Share on other sites
schoondoggy

I would try updating BIOS, iLo, IP and all other firmware to see if that gets it working.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×