As I have decided to make some improvements on my afermarket fan controller I am trying to try implementing thermal control or mobo PWM control of additional fans, but before that I'm in a great need to inderstand how much fan count the controller should be ready to support. As this forum doesn't support polls I have nothing to do but ask you to reply on this topic.
What I would be thankful to know:
1. How many fans have you installed in your Microserver.
2. What fans do you use (size, 3/4-pin connector) and where are they located, also what are they cooling.
3. What way do you power these fans?
Thank you in advance for your feedback!
My HP Proliant Microserver Gen 8 won't install HP Tools when I have running HP Smart Update Manager.
even when I have trying to install via Intelligent Provising, Windows Server 2019.
Se image below 🙂 That's I missing.. ;-(
New to this forum.
I have a gen8 microserver running at home, where I have installed an SSD in the ODD sata slot. On the SSD I have installed Ubuntu Server 18.04.
I have then created a logical volume witht the raid controller and can then boot to the SSD. So far so good.
My problem emerges when I reboot the system. The logical volume disapears and it gives the error: "boot logical drive is configured but is missing or offline".
I then have to go into the utility and reconfigure the logical volume. Kind of annoying, when trying to run a headless setup.
Good day all
i bought a gen 10 x3216 MicroServer and I have been trying to install windows server 2016 on it with a usb and I get it to boot into the usb with the iso on it but I can not get past the one install step where u supposed to select the drive.
instead it says to download storage drivers and browse to select driver. I have downloaded every single storage driver from the hpe site or is sure does feel like it.
if I try to select the driver I have to do so manually by unticking show only compatible drivers because if I leave it ticked there is nothing compatible. Iam stumped on what the correct driver is.
ok so what Iam trying to do isssssss I want to install the os onto the usb that I have attached inside the box the one that is directly coming off the board. Is that a different driver ?
In bios/boot up options I can see all usb connected.
can anyone please help me with this
By Mark Belanger
I'm new to the HPMSG8 world and so far I'm loving it. I have a stock Xeon with 16G of aftermarket memory with iLO patched to 2.70. Next up is adding a RAID card, so I can put my boot SSD on the onboard RAID. I picked up a LSI SAS9211-8i on Amazon, but am struggling to flash it to IT mode on the MicroServer. Is this even possible? Unfortunately, the only other system I have with PCI slots is 32-bit.
Any pointers would be greatly appreciated.