-
Similar Content
-
By Sokoban
Hi
My HP Proliant Microserver Gen 8 won't install HP Tools when I have running HP Smart Update Manager.
even when I have trying to install via Intelligent Provising, Windows Server 2019.
Se image below 🙂 That's I missing.. ;-(
-
By Karazzi
Hi everyone.
New to this forum.
I have a gen8 microserver running at home, where I have installed an SSD in the ODD sata slot. On the SSD I have installed Ubuntu Server 18.04.
I have then created a logical volume witht the raid controller and can then boot to the SSD. So far so good.
My problem emerges when I reboot the system. The logical volume disapears and it gives the error: "boot logical drive is configured but is missing or offline".
I then have to go into the utility and reconfigure the logical volume. Kind of annoying, when trying to run a headless setup.
-
By Mark Belanger
Greetings,
I'm new to the HPMSG8 world and so far I'm loving it. I have a stock Xeon with 16G of aftermarket memory with iLO patched to 2.70. Next up is adding a RAID card, so I can put my boot SSD on the onboard RAID. I picked up a LSI SAS9211-8i on Amazon, but am struggling to flash it to IT mode on the MicroServer. Is this even possible? Unfortunately, the only other system I have with PCI slots is 32-bit.
Any pointers would be greatly appreciated.
-MB
-
By TakiBot
I've got my hands on a HP N40L.
Can i use raid 1+0 on my 4 2TB WD RED or only 1 and 0.
Thanks for the help.
-