Jump to content
RESET Forums (homeservershow.com)
  • ×   Pasted as rich text.   Paste as plain text instead

      Only 75 emoji are allowed.

    ×   Your link has been automatically embedded.   Display as a link instead

    ×   Your previous content has been restored.   Clear editor

    ×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Content

    • AllanHP
      By AllanHP
      Hello guys, i have a HP ProLiant ml350p g8 I had installed one gpu card rx580 strix and I had used one gpu frequency  management call asus gpu tweakll, when I change gaming mode to silence mode my computer restart and I saw one red light on the motherboard, I fix the problem I had installed one old version of the asus tweakll, now the computer works well, but the red light still on, I used the software OCCT I checked psu memory gpu voltages run many testes and pass in all tests, I try to find in the manual what this red light is but I can't find, thanks for the help.

    • Sokoban
      By Sokoban
      Hi 
      My HP Proliant Microserver Gen 8 won't install HP Tools when I have running HP Smart Update Manager. 
      even when I have trying to install via Intelligent Provising, Windows Server 2019.
       
      Se image below 🙂 That's I missing.. ;-(
       

    • Karazzi
      By Karazzi
      Hi everyone.
       
      New to this forum.
      I have a gen8 microserver running at home, where I have installed an SSD in the ODD sata slot. On the SSD I have installed Ubuntu Server 18.04.
      I have then created a logical volume witht the raid controller and can then boot to the SSD. So far so good.
      My problem emerges when I reboot the system. The logical volume disapears and it gives the error: "boot logical drive is configured but is missing or offline".
      I then have to go into the utility and reconfigure the logical volume. Kind of annoying, when trying to run a headless setup.
       
    • Mark Belanger
      By Mark Belanger
      Greetings,
       
      I'm new to the HPMSG8 world and so far I'm loving it. I have a stock Xeon with 16G of aftermarket memory with iLO patched to 2.70. Next up is adding a RAID card, so I can put my boot SSD on the onboard RAID. I picked up a LSI SAS9211-8i on Amazon, but am struggling to flash it to IT mode on the MicroServer. Is this even possible? Unfortunately, the only other system I have with PCI slots is 32-bit.
       
      Any pointers would be greatly appreciated.
       
       
      -MB
    • TonyTheTechie
      By TonyTheTechie
      I need to update the firmware on a HP Proliant Microserver Remote Access Card installed in my N40L.
       
      Can someone please explain what I need to do to create a boot device that will update the firmware on the Remote Access Card?
       
      Thanks
       
      Tony Self


×
×
  • Create New...