Jump to content
RESET Forums (homeservershow.com)

Startech PEXSAT32 RAID config unavailable


Helzy
 Share

Recommended Posts

Anyone use one of these? I am unable to ctrl+m on post to get to the RAID config. It's not the card, I have 2 exact same behaviour where I cannot access that RAID setup:

 

https://www.startech.com/Cards-Adapters/HDD-Controllers/SATA-Cards/2-Port-PCI-Express-SATA-6-Gbps-Controller-Card~PEXSAT32

 

I am using it in an HP Envy Phoenix H9-1386 https://support.hp.com/us-en/product/hp-envy-phoenix-h9-1300-desktop-pc-series/5295991/model/5296899/document/c03516358 with secureboot turned off (and tried it on it doesn't matter). 

 

Driving me nuts...

Link to comment
Share on other sites

The board uses a Marvell chip. I have had issues with the ctrl+m with UEFI BIOS PCs. Can you turn off UEFI and set it to legacy boot? You can also set Marvell based cards up with MSU: From the Startech link above drivers and downloads.

Link to comment
Share on other sites

Yup did that too. Simply no luck. It will allow me into the Intel raid. Buddy brought his ex-mining rig to work so I planted one in and got to the raid bios that way. Made a two separate raid sets and popped them back into the pegatron board and that worked. Annoying as hecm. But it worked.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

×
×
  • Create New...